Industrial fan

Inject new vitality into your system

Industrial high-performance hot air blower

No need for expensive fan upgrades to increase speed

The higher the fan speed, the more heat is generated by the bearings. If you want to achieve and maintain high-speed operation, sometimes you may need to upgrade the lubrication method of your fan: you may have to upgrade to higher cost oil bath lubrication, or even more expensive circulating oil lubrication.

However, in some cases, the speed can be increased without changing the lubrication method. The self-aligning bearing system for IMCB industrial fans and hot air fans allows for higher speeds and can help you address these issues. Optimizing the combination of components without the need for expensive lubrication upgrades, IMCB’s full shaft solution can extend the lubrication interval, reduce energy consumption, and improve the reliability of fans lubricated with grease and oil.

Self aligning bearing system

– Excellent solution for axis alignment error
– Industrial fans typically operate at high speeds and light loads. High speed may cause excessive bearing temperature. In addition, the fan itself may also generate high process temperatures, which are then transmitted to the fan shaft. This may cause significant axial expansion of the shaft. The expansion of the suspension shaft may be significant, and the bearing is located on the opposite side of the impeller.
– The solution for wind turbine applications has always been to use self-aligning ball bearings or spherical roller bearings for both fixed and non fixed ends of the bearing system. That is to say, the non fixed end bearing must be able to freely move axially in the bearing seat hole, so once it gets stuck, there will be problems. Blocked bearings may cause an increase in load, temperature, and axial vibration on the bearings.